AddPay_hub_cnp_cybersource – Configuration (PayCloud Front-End)

Overview

This article provides a step-by-step guide to configure CyberSource (CNP) integration on the AddPay PayCloud platform for front-end users. It focuses on enabling the payment channel, setting transaction fee rates, and adding parameter settings.

Prerequisites

Before starting, ensure you have:

• Access to the AddPay PayCloud front-end.

• Termsheet with the agreed transaction fee rates.

• Knowledge of the CyberSource Merchant ID (MID),  AddPay Config UUID and TID. 

Important: The CyberSource MID and AddPay Config UUID are the same for all merchants:

• Bank MID: 000000003065026

• AddPay Config UUID: a263bc28-5865-455c-a53f-46cdc9f0e2f1


• Terminal ID (TID): 032076

Configuration Steps

1. Enable the Payment Channel

1. Navigate to Payment Channels in AddPay PayCloud.

2. Locate AddPay_hub_cnp_cybersource.

3. Enable the payment channel if it is not already active.
   
   

2. Configure Transaction Fee Rate

1. Go to Transaction Fee Rate Settings.

2. Set the fee rates according to the termsheet agreement.

3. Verify that all percentages or flat fees match exactly as specified.
   
   
   

3. Add Parameter Settings

1. Navigate to Parameter Settings for the CyberSource payment channel.

2. Enter the following parameters:

   • Bank MID: 000000003065026

   • AddPay Config UUID: a263bc28-5865-455c-a53f-46cdc9f0e2f1


   • Terminal ID (TID): 032076


     
     
     
     
     

3. Save changes.

4. Verification

• Confirm that the CyberSource MID and UUID match the standard values.

• Optionally, perform a test transaction to ensure configuration is correct.

Notes

• The CyberSource MID, AddPay Config UUID and TID remain the same for all merchants.

• Keep a record of these values for audit and troubleshooting purposes.